MCP18480T-I/SS【PDF 35/64 页】IC HOT SWAP CTRLR -48V 20SSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录44

31页 32页 33页 34页 [35页]36页 37页 38页 39页

?2003 Microchip Technology Inc.

DS20091B-page 35

MCP18480

TIMER

Current Limit Timer.

The value of the external capacitor (C

TIMER

) connected to the TIMER

pin sets the two time periods used during a current-limit event. These

are:

" The time that the GATE pin will limit the current through the

external FET

" The time that the GATE pin will disable the external FET

During current limit, a pull-up current source charges up the external

capacitor. Until the voltage on the TIMER pin reaches V

REFIN

/2, the

GATE pin is driven to maintain a reduced current flow determined by

the V

of the external FET.

While the capacitor is being discharged by the pull-down current (pull-

up current is off), the GATE pin is at V

NEG

and the PWRGOOD pin is

deasserted. When the TIMER voltage falls below approximately

100 mV, the GATE pin turns on, if the RESTART

pin is low, to reset the

internal fault latch. If the RESTART

pin is high, the GATE pin remains

off until the ENABLE pin is forced low. It is then forced high or the

RESTART

pin is forced low (asserted).

The PWRGOOD pin reasserts after the voltages on the DRAIN

and

GATE pins meet the appropriate conditions.

The TIMER pin pull-up current is proportioned to the I

ISET

current

(approximately a multiple of 16).

NEG

Negative supply input.

The negative voltage applied to the board by the backplane (typically

the most negative voltage in the system).

DISCH

External MOSFET activation delay.

An external resistor (R

RDISCH

) is connected between the R

DISCH

and the V

NEG

pin and is used to set the delay between the deactivation

and activation of the external pass MOSFET during a current-limit

event. The delay is set by the values of the external capacitor (C

TIMER

)

and the external resistor (R

RDISCH

). The formulas are:

DEACT

= (C

TIMER

x R

ISET

) / 16

ACT

= (9.2 x R

RDISCH

x C

TIMER

)

TABLE 3-1:

MCP18480 PIN DESCRIPTIONS (CONTINUED)

Pin Name

Number

Direction

Buffer

Type

Description

SSOP

Legend: TTL = TTL compatible input

ST = Schmitt Trigger input with CMOS levels

I = Input

O = Output

P = Power

CMOS = CMOS-compatible input

A = Analog

D = Digital

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式